Many readers have asked for more concrete directions on how to make the no-sew tutu, so here’s a more detailed post with photo directions.
Cut elastic to waist size and pin together with a safety pin or a few stitches. Cut lengths of tulle from a 6-inch-wide tulle ribbon roll. Fold the tulle piece in half and then thread the ends through itself around the elastic.
To demonstrate, I’m using a spare piece of elastic and a spare piece of ribbon, but this is the exact same technique you would use with a strip of tulle.
Start with your band of elastic and piece of ribbon or tulle. Fold your piece of ribbon in half, place the loop end under the elastic.
Pick up the loose ends of the ribbon. Pull them over the elastic and through the loop end of the ribbon.
Pull the loose ends of the ribbon to tighten it around the elastic. And then repeat with additional pieces of ribbon and tulle until the tutu is as full as you’d like. Yay!
For the tutu pictured at the top, we used an entire roll of champagne colored shimmer tulle (25 yards). It provided 33 lengths (about 2 feet long each) to tie to the waist band. We also used 3 rolls of ribbon in peach, cream and sage green. They provided 11 lengths each and were attached between the tulle pieces for accents. The materials were under $5 total.
Another note about this project. You can make the tutu any length you like, by using longer or shorter pieces of tulle. Also. If I’d had another roll of the tulle, I would have used it and made the tutu twice as full.
